mail us  |  mail this page

products  |  company  |  support  |  training  |  contact us

Multicast Router - QoS

QoS Features

Powerful Quality of Service (QoS) features allow user control of traffic flowing through router. Application Specific Gateways (ASGs) enable secondary ports to be automatically assigned the same priority levels.

User configurable allocation of priority (High, Medium and Low).

The user may configure the router to allocate a Priority rating to ISDN traffic types. The priority values (High, Medium and Low) will determine the order traffic is processed internally and dispatched to the ISDN line. Finally in a case of overload the Priority rating will determine the order in which traffic is discarded.

go up

User configuration of ‘Service Ratio’ allocated to each priority level.

The 'service ratio' determines the number of times a priority queue is serviced before the router moves to the next priority level. This parameter may be used, among many others uses, to ensure that even low priority traffic receives some level of service and is not 'starved' even in high load situations. to illustrate the use of the 'service ratio' parameter assume that High Priority traffic is given a 'service ratio' of 5, Medium 3 and Low 1. The router will service the High priority queue 5 times (e.g. send 5 blocks to the ISDN line) or until the queue is empty if sooner, then service the medium Priority queue 4 times or until empty if sooner, then service the Low Priority queue once if there are any items on it.

go up

Priorities may be assigned based on traffic type (TCP, UDP, ICMP), source IP address, Subnet Mask, port number (or port number range). or destination IP.

The user may configure the priority value based on the IP address (source or destination) or IP address range (using a net mask). the traffic type (UDP, TCP, ICMP etc.) and the port number or port range. As many or a few values as necessary to identify the specific traffic may be defined e.g. UDP only, all traffic to this IP etc.

go up

Up to 8 Priority assignment definitions are supported.

Up to 8 Priority assignments may be defined by Traffic Type, Source IP address, Destination IP address and port number or range. Any values not defined are defaulted to Low Priority, except traffic generated and destined for the router which is automatically assigned a special value.

go up

H.323 and SIP context sensitive assignment of priority to ‘spawned’ connections.

Certain protocols use secondary ports or 'spawn' additional ports in their normal operation. H.323 and SIP are such protocols. If the router is configured to recognize port 1720 (the H.323 control port) then the priority rating assigned to this port is automatically allocated to all secondary or 'spawned' ports during that H.323 call sequence.

go up

FTP context sensitive assignment of priority to ‘spawned’ connections.

Certain protocols use secondary ports or 'spawn' additional ports in their normal operation. FTP is one such protocol. If the router is configured to recognize port 21 (the FTP control port) then the priority rating assigned to this port is automatically allocated to all secondary or 'spawned' ports during that FTP session.

go up

features
general
bandwidth
dhcp
firewall
warp hardware
multicast
nat
isdn protocols
qos
routing
security
hotpools
management
utilities
dual-boot

If you are happy it's OK - but your browser is giving a less than optimal experience on our site. You could, at no charge, upgrade to a W3C STANDARDS COMPLIANT browser such as Mozilla

Services

Development Services
Consulting Services
Training Services
Tech Stuff Pages
Open Guides

Display full width page Full width page

Print this page Print this page

SPF Record Conformant Domain Logo

Copyright © 1994 - 2014 ZyTrax, Inc.
All rights reserved. Legal and Privacy
site by zytrax
Hosted by super.net.sg
web-master at zytrax
Page modified: July 11 2011.